Subharmonicon
For general troubleshooting of the Subharmonicon, we recommend following the steps: 1. Perform a NOTE CALIBRATION by checking through the following ...
Mon, 29 Sep, 2025 at 11:57 AM
By default, Subharmonicon is set to CH 1. You can change this by sending the instrument a SysEx file, which you can find HERE. Sending SysEx to SU...
Wed, 1 Oct, 2025 at 3:34 AM
If you are having trouble updating your instrument, please consider the following points: Verify that you have as direct a connection as possible ...
Mon, 29 Sep, 2025 at 11:55 AM
Each sequencer controls the corresponding pitch of it's oscillator and sub oscillators; however, both oscillators go through the same VCA and VCF. ...
Mon, 29 Sep, 2025 at 11:59 AM
Adjusting the oscillators to a specific key isn't readily apparent on the front of the Subharmonicon. By default, the oscillator is set to the key ...
Wed, 10 Sep, 2025 at 3:31 AM
To synchronize the Subharmonicon with another analog clock-enabled hardware instrument, like the Mother 32, follow these steps: Ensure that your cl...
Tue, 21 Oct, 2025 at 11:38 AM
The Subharmonicon can accept MIDI data through the MIDI IN jack utilizing the supplied TYPE A MIDI adapter. You will require a MIDI INTERFACE that link...
Tue, 21 Oct, 2025 at 11:44 AM
Connect the Subharmonicon's CLOCK output jack to the DFAM's ADV/CLOCK input jack using a patch cable. This setup will enable t...
Tue, 21 Oct, 2025 at 11:50 AM
Disconnect external power from the unit. Remove the eight black M3 screws on the front panel and keep them somewhere safe. You will need them a...
Tue, 21 Oct, 2025 at 11:55 AM
Yes. By default, the SEQ 1 and SEQ 2 output jacks will output a control voltage that reflects the current Quantize settings. This behavior can be disengaged...
Thu, 29 Jun, 2023 at 3:10 PM