inMusic Support

For general troubleshooting of the Grandmother, we recommend the following steps in order: Reset all GLOBAL SETTINGS  Hold down the HOLD and SYNC...

Building upon the guidance from the "Editing Parameters Using MIDI Sysex Messages" section of the Grandmother manual, you can refer to the fo...

First, make sure that you have modulation assigned to something (pitch, filter, etc.). Patch from the KB GATE output in the ARP/SEQ module, to the S...

Just patch from the KB PITCH output on the ARP/SEQ module into the RATE input on the MODULATION module. Then patch from the WAVE output in the MODULATI...

If your keyboard is producing notes that appear too low or too high in pitch, it's likely that the octave range of your Grandmother’s keyboard has ...

Patch from the MIXER output to the HIGH PASS filter input. Then patch from the HIGH PASS filter output to the NOISE input on the Mixer. The NOISE level...

Over time, Grandmother’s analog oscillators may need to be recalibrated. To do this, enter Global Edit Mode by holding the SHIFT and HARD SYNC buttons ...