inMusic Support

For general troubleshooting of the Subharmonicon, we recommend following the steps: 1. Perform a NOTE CALIBRATION by checking through the following steps...

By default, Subharmonicon is set to CH 1.  You can change this by sending the instrument a SysEx file, which you can find here.  Sending SysEx to SUBHARMON...

If you are having trouble updating your instrument, please consider the following points:  • Verify that you have as direct a connection as possible to yo...

Each sequencer controls the corresponding pitch of it's oscillator and sub oscillators; however, both oscillators go through the same VCA and VCF. There...

Yes.  Using the Fine Tune mode, the overall pitch of your Subharmonicon can be adjusted by ± 50 cents (one-half semitone up or down). This allows Subharmoni...

To sync Subharmonicon to another analog clock equipped hardware instrument, such as Mother 32, you’ll need to: Confirm that your clock source, in this ca...

Subharmonicon can receive MIDI data at the MIDI IN jack using the included Type A MIDI adapter.  You’ll need a MIDI interface that connects to your computer...

Using Subharmonicon to clock DFAM Use a patch cable to connect the Subharmonicon CLOCK output jack to the DFAM ADV/CLOCK input jack.                 Thi...

Disconnect external power from the unit.     Remove the eight black M3 screws on the front panel and keep them somewhere safe. You will need them again....

Yes. By default, the SEQ 1 and SEQ 2 output jacks will output a control voltage that reflects the current Quantize settings. This behavior can be disengaged...