inMusic Support

9 Volts 300mA or more (500mA is common and will work fine) and make sure the TIP is set to Positive "+". Look for the opening in the centre ...

If the signal passes through the pedal, but you cannot hear the effect of the pedal, this may indicate component level issues. If this is the case, con...

All Moogerfoogers output a line level signal. Instrument level signals typically only come from instruments, such as an electric guitar or bass.

The MF-108 and MF-105 standardize the CV to a midpoint of 2.5V when not in active use. This enables external CVs to adjust the CV value in both positiv...

The default MIDI Channel for the MF-108M is Channel one. To change this, press and hold both the Tap Tempo and Bypass switches. While holding both, sen...

An expression pedal for use with Moogerfoogers should contain a 50K or 100K potentiometer which is connected from the sleeve to the ring terminals of t...

No. In the MF-101 and MF-102, the signal always goes through the preamplifier and drive circuits, so the drive control is always active.  In the MF-10...

The MF-108 and MF-105 nominalize the CV to the mid point of 2.5V when not actively used. This allows an external CVs to pull the CV value in both the p...

Check to see if you are on “Pattern 1.” On both the BASS and MID settings PATTERN 1 will act as a simple graphic EQ and will ignore the RATE settings.

Using a TS (mono) cable out of the LOOP OUT you can send the delayed signal to the input of just about any FX you can imagine. Use the output of the FX...