inMusic Support

For general troubleshooting of the Grandmother, we recommend the following steps in order: Reset all GLOBAL SETTINGS  Hold down the HOLD and SYNC but...

Building off of the instructions from the Editing Parameters Using MIDI Sysex Messages portion of the Grandmother manual, you can use the following example ...

First, make sure that you have modulation assigned to something (Ex. Pitch, Filter, etc..). Patch from the KB GATE output in the ARP/SEQ module, to the S...

Just patch from the KB PITCH output on the ARP/SEQ module into the RATE input on the MODULATION module. Then patch from the WAVE output in the MODULATION mo...

If your keyboard is triggering notes that seem too low or high in pitch, your Grandmother’s Keyboard Octave Range has likely been transposed. To lower the o...

Patch from the MIXER output to the HIGH PASS filter input. Then patch from the HIGH PASS filter output to the NOISE input on the Mixer. The NOISE level knob...

Over time, Grandmother’s analog oscillators may need to be recalibrated. To do this, enter Global Edit Mode by holding the SHIFT and HARD SYNC buttons down ...