While there is no direct CV control for the wave folder, this can be approximated in several ways:
- Patch the ATTN out to the ONE (-5) input jack of the mixer.
- Patch VCO out to the TWO input jack.
- Patch the ONE + TWO output to FOLD IN
- Turn the ONE LVL knob at its rightmost position.
- Try patching the LFO out into the ATTN (+5) input and adjusting the LFO rate and attenuator rate knobs to get varying levels of modulation.
___________________________________________________________________________________________________
- Patch the LFO out to the ONE (-5) input jack of the mixer.
- Patch VCO out to the TWO input jack.
- Patch the ONE + TWO output to FOLD IN.
- Turn the ONE LVL knob at its rightmost position.
- Adjust LFO rate