If you are experiencing difficulties loading an Amp Clone within ReValver 5, this may be due to the audio device within the plug-in not being configured correctly. Here are the steps to resolve this via your audio setup within ReValver:


TABLE OF CONTENTS


Windows - How to Resolve

  1. Navigate to Settings via the cog icon in the top-right corner.
  2. Launch Audio/MIDI Device Manager
  3. Select the Audio Device Type and Device:
    • This will be an ASIO or WDM/Windows Audio device
    • If ASIO is selected, you can then select the Device
  4. Ensure the correct Output and Input Options are selected
    If no Output or Input is selected, you may experience issues loading content within ReValver.
  5. Configure Sample Rate and Buffer Size.


MacOS - How to Resolve

  1. Navigate to Settings via the cog icon in the top-right corner.
  2. Launch Audio/MIDI Device Manager
  3. Select Input and Output
  4. Ensure the correct Output and Input Channels are selected
    If no Output or Input is selected, you may experience issues loading content within ReValver.
  5. Configure Sample Rate and Buffer Size.


Loading an Amp Clone in ReValver

Once these settings are configured, you'll be able to load an Amp Clone in ReValver 5. To load an Amp Clone within ReValver, follow the steps below:


  1. Go to AMP & CAB A
  2. Click the Add Module icon
  3. Select Headrush Amp Cloner Player
  4. Click on the Clone search bar
  5. Browse or Search the Clones page - load your preferred Amp Clone


If you continue to encounter problems, please reach out to our customer support team for further assistance.