If you are unable to save changes to your kits, instruments or sequences on the DM10, it may be that the module is still in the default write-protected state.


To disable this, please see the following:


1. Press UTILITY.

2. Press SYS (F4).

3. Press O/S (F3).

4. Press MEM (F4).

5. Press VALUE DOWN or move the VALUE DIAL counterclockwise until the "WriteProt" field says "OFF."

6. Press DRUM KIT to return to the main page. 


If you experience any further issues, please do not hesitate to contact our support team here.